Pin cho iPhone 7PLUS
Giá bán lẻ đề xuất: 
500.000 VNĐ

Được thiết kế chuẩn dung lượng Iphone 7 PLUS

- Tổng số lần sạc / vòng đời sản phẩm lý tưởng: 500-800 lần

- Thời gian làm việc : 2-3 năm

- Dung lượng :2900mAh（11.10whr）

- Điện áp lý tưởng :3.82 V

- Điện áp sạc: Max.4.3 V

Áp dụng công nghệ chuẩn pin Li-on Polyme.

- Chuẩn CE Châu Âu, trọng lượng pin nhẹ.

- Chống cháy nổ, an toàn tuyệt đối.

- Nguyên liệu: Li-ion polymer

Vòng đời sản phẩm :Trên 1000 lần sạc

Hướng dẫn thay thế pin iPhone 7 Plus.

Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

Apply a suction cup to the lower half of the front panel, just above the home button.

Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.

Insert the flat end of a spudger into the gap.

The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.

 

​

 

 

Insert the flat end of the spudger between the front panel and the rear case at the lower left edge of the iPhone.

Insert the flat end of the spudger between the front panel and the rear case at the lower left edge of the iPhone.

 

Remove the spudger from the left side of the phone and insert the flat end into the bottom right corner.

  •  
  •  

Pull up on the suction cup to lift up the display and open the iPhone.

  •  
  •  

Pull up on the small nub on the suction cup to remove it from the front panel.

Slide an opening pick underneath the display along the top edge of the phone to loosen the last of the adhesive.Slide an opening pick underneath the display along the top edge of the phone to loosen the last of the adhesive.

Pull the display assembly slightly away from the top edge of the phone to disengage the clips holding it to the rear case.Open the iPhone by swinging the display up from the left side, like the back cover of a book.Don't try to fully separate the display yet, as several fragile ribbon cables still connect it to the iPhone's logic board.

Remove the following four tri-point Y000 screws securing the lower display cable bracket to the logic board:

 

Remove the lower display cable bracket.

Remove the lower display cable bracket.

 

Use the point of a spudger to lift the battery connector out of its socket on the logic board.Bend the connector cable up slightly to prevent it from making contact with the socket and providing power to the phone.

 

 

 

*
*
4 + 7 =
Tính các phép tính đơn giản này và nhập kết quả vào. Ví dụ: cho 1+3, hãy nhập 4.